Home

Home > Products Catalog > PRIMUS WATER BASE > High Solid Rubber Series > Econo Series

Econo Series

Econo Clear & White
Econo 10055MB & 20056MB

 
This product series is a water base ink developed to an cost-effective range of rubber clear and white into both shinny and matt finish. A ready product to use, it gives a good stretching ability on knitted fabric as well as provides a non-tacky characteristic.
 
Specialty:
 
  • Very good elasticity.
  • Good all round fastness.
  • Non-tacky.
  • No harmful or distracting odors in the work place.
  • PVC, phthalate, APEO, Azo and Lead Free formulations, Meets all key international environmental standards.
Guidance:
  • Use 100-120 t/in mesh (40-47 t/cm)
  • Direct to print on fabrics, apply 100% Econo Clear as a first down coat is suggested to increase the utmost elasticity. Then print colors with different mixture ratio of Econo Clear & White sequent on top.
  • For dark ground fabric, Econo White is a high opaque white to give high coverage.
  • Surface dry each print before next is necessary to avoid color tacky up.
  • To prolong its screen opening time is recommended to add 2-3% of Additive Retarder.
  • To enhance better fastness is recommended to add 2-4% of Additive Xlinker JF, consuming the mixed solution in 6-8 hours.
Precautions:
  • Keep the screen in the flooded position while print stops. Or, go for screen wash during a temporary stop.
  • Containers must maintain air-tight seal while not in use.
  • During Production, heat application can be applied to speed up the process. Failure to cure ink at recommended time and temperature may result in poor wash fastness.
  • Screen must be prepared with water-resist emulsion to prevent stencil breakdown.
  • Any application not referred in this Product Information should be Pre-tested or consulted with Primus Technical Service Prior to Print.

Printing Parameters:

100% Cotton/Poly Cotton/Blended Gel: 150℃ x 1.5 minutes
Durometer: 60-70 
Edge: Rounded or Sharp
100-120t/in(40-47t/cm)
Add. Xlinker JF 2-4% by weight.
Add. Retarder 2-3% by weight.
5-40℃
Use within one year of receipt. Avoid exposing under direct sunlight. Keep drums sealed tight at all times

Tap water 
Available upon request (MSDS)
 
All Rights Reserved by Primus Chemical Co.,Ltd.