Home

Home > Products Catalog > PRIMUS WATER BASE > Special Effect Series > Watermark IV-4

Watermark IV-4

 
 
Details: 
This product is a specialized formulation to create an invisible mark on fabric where it can’t be seen while fabric is dry, and where it can be seen while fabric is wet.
 
Specialty:
  • Non hand feel and transparency appearance.
  • A magic invisible effect for sportswear.
  • PVC, phthalate, APEO, Formaldehyde, Azo and Lead Free.  Meets all key international environmental standards.
  • No harmful or distracting odors in the work place.

Guidance:
  • Select sportswear blended fabrics or polyester lycra fabric to get best performance.

       

         Formula: Watermark IV-4......................100%
                         Add. Xlinker Low Cure............1-3%
                         Ready Paste......................... 100%

 

  • Mixed paste is recommended to be consumed out by 1-2 hours. Recommend to print 1 coat only in order to avoid any ghost image. 
  • After pattern is printed, the curing or heat-press process is recommended within 1-2 hours to retain the best washing durability.
Precautions:
 
  • Keep the screen in the flooded position while print stops. Or, go for screen wash during a temporary stop.
  • Containers must maintain air-tight seal while not in use.
  • In-sufficient curing may cause burn out paste spread out of original pattern on fabric. Moreover, polyester part may be deteriorated or stained if wash off is being delayed.
  • Containers must maintain air-tight seal while not in use.
  • During Production, heat application can be applied to speed up the process. Failure to cure ink at recommended time and temperature may result in different effect.
  • Screen must be prepared with water-resist emulsion to prevent stencil breakdown.
  • Any application not referred in this Product Information should be Pre-tested or consulted with Primus Technical Service Prior to Print.

Printing Parameters:

Sportswear fabric or polyester lycra 150℃ × 2-3 minutes or
155℃ x 20-30 seconds(heat press)
Durometer: 60-65 
Edge: Sharp
100-200t/in (39-77 t/cm)
Additive Xlinker Low Cure
5% by weight.
 
5-40℃
Use within one year of receipt. Avoid exposing under direct sunlight. Keep drums sealed tight at all times

Tap water 
Available upon request (MSDS)
 
All Rights Reserved by Primus Chemical Co.,Ltd.