Home

It is a water base ink developed to produce a very unique characteristic and break-through technology on automatic printing machine. Slow drying property gives adequate time range to run continuously without screen clogged from the hot plate.

Specialty:
 

• Excellent coverage and stretching.
• All round fastness durability.
• PVC, phthalate, APEO, Azo and Lead Free formulations.Meets all key international environmental standards.
• Suitable on manual and automatic machine.
• No harmful or distracting odors in the work place.

Guidance:
 

• Use 100-120 t/in mesh (40-47 t/cm).
• Ready for use, No any other additive is required. Well stirred the paste before using.
• Avoid wet on wet printing application.
• To create certain coverage on dark ground, increase times of coating is required.
• For fine mesh design, Additive Retarder is required to be added by 2-3% to prolong its drying time.

Precautions:
 

• Keep the screen in the flooded position while print stops. Or, go for screen wash during a temporary stop.
• Containers must maintain air-tight seal while not in use.
• During Production, heat application can be applied to speed up the process. Failure to cure ink at recommended time and temperature may result in poor wash fastness.
• To meet superior wash, adding Additive Xlinker JF 1-3% by weight is necessary.
• Screen must be prepared with water-resist emulsion to prevent stencil breakdown.
• Any application not referred in this Product Information should be Pre-tested or consulted with Primus Technical Service Prior to Print.

Printing Parameters:

	100% Cotton/Poly Cotton/Blended		Flash: 160℃ x 10-15 seconds Cure: 160℃ x 3 minutes
	Durometer: 60-70  Edge: Rounded or Sharp		100-120t/in(40-47t/cm)
	Additive Xlinker Low Cure 3-5% by weight. Additive Thickener NFR 1% Max. by weight.	​	5-40℃ Use within one year of receipt. Avoid exposing under direct sunlight. Keep drums sealed tight at all times
	Tap water		Available upon request (MSDS)