Fluorescent Colors
Details:
PLASTeco NP series, Non-PVC/Non-Phthalate Plastisol inks, is specially invented by Primus Chemical with the same printing parameter as vinyl plastisol ink system without any change on printing equipment. Ready for use, 8 colors available in NP-Fluorescent color series with slight opacity and elongation characteristic. Easy to run on automatic machines with quick flash property to enhance the maximum productivity.
Specialty:
- Excellent all round durable fastness.
- Print through fine mesh, print-flash-print or wet on wet process.
- Soft finish prints and high glossy effect.
- High resistance in bleeding.
- No harmful or distracting odors in the work place.
Guidance:
- This can be used straight from the drum. Well stirring before applying is very important.
- Plastisol Ultimate Polar White is a premium Flash White for a purpose of under base printing on dark ground that can provide the best coverage and helpful for sequence Fluorescent color to print on.
- Viscosity can be reduced by adding different percentage of Plastisol 700 Reducer to meet client’s intended viscosity and gel or curing will not be affected.
- To create a superior soft hand touch, Plastisol 710 Softener can be mixed 10% max by weight. Over dosage may occur difficulty in drying or curing.
Precautions:
Printing Parameters:
- All the above printing guides are required to adjust the off-contact distance, squeegee pressure and blade speed to meet up intended performance, best coverage and brightest print.
- DO NOT add or mix PVC or Phthalates ink with PLASTeco NP Inks.
- Avoid excessive over-flashing, as it can result in poor inter-coat adhesion of overprint colors.
- Any emulsion compatible with Plastisol inks.
- Failure to cure ink properly can result in poor wash fastness, inferior adhesion, and unacceptable durability.
- Do not dry clean, bleach or iron printed area.
- Containers must maintain seal while not in use.
- On some types of fabric, dye migration may occur. Hence, fabric pre-testing is necessary before bulk production.
- Any application not referred in this Product Information should be pre-tested or consulted with Primus Technical Service prior to print.
Printing Parameters:
100% Cotton/Poly Cotton/Athletic wear/ Synthetic fabrics |
Gel: 120-140℃(229℉) x 4-6 seconds Cure: 150-160℃(319-355℉) ×3 minutes |
||
Durometer: 70-80 Edge: Rounded or Sharp |
100-305t/in (39-120t/cm) | ||
Additive 700 Reducer 10-20% by weight Additive 710 Softener max. 10% by weight |
18-40℃(65-90℉) Use within one year of receipt. Avoid exposing under direct sunlight. Keep drums sealed tight at all times. |
||
Additive Screen Cleaner | Available upon request (MSDS) |